Induced voltage working procedures for underground transmission circuits are established in this guide. A transmission circuit when de-energized will have an induced voltage when in a common duct bank with an energized circuit. The induced voltage may be a possible safety hazard. The induced voltage may be determined by modeling the circuits and by measurement. This guide addresses the working procedures to follow when performing work where induced voltage is present.
- Standard Committee
- PE/IC - Insulated Conductors
- Status
- Active Standard
- PAR Approval
- 2014-06-12
- Board Approval
- 2015-02-16
- History
-
- Published:
- 2015-02-20
Working Group Details
- Society
- IEEE Power and Energy Society
- Standard Committee
- PE/IC - Insulated Conductors
- Working Group
-
C29W/P1727_WG - Induced Voltage Work Procedures
Learn More About C29W/P1727_WG - Induced Voltage Work Procedures - IEEE Program Manager
- Michael Kipness
Contact Michael Kipness - Working Group Chair
- Nijam Uddin
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
No Active Projects
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
1727-2013
IEEE Guide for Working Procedures on Underground Transmission Circuits with Induced Voltage
Induced voltage working procedures for underground transmission circuits are established in this guide. A transmission circuit when de-energized will have an induced voltage when in a common duct bank with an energized circuit. The induced voltage may be a possible safety hazard. The induced voltage may be determined by modeling the circuits and by measurement. This guide addresses the working procedures to follow when performing work where induced voltage is present.
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
No Superseded Standards
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards