This standard provides requirements for the preparation of a functional specification for a solid-state electronic series and shunt device used mainly to compensate for voltage fluctuation. The standard covers series and shunt devices rated to medium voltage. In general, a series device contains: a bidirectional converter, an energy storage device, and an injection transformer connected in series with the load and a normally open by-pass switch. A shunt device contains the same components as a series device except for a coupling transformer connected in parallel. The standard also covers the following equipment to assure proper interface with the electric network including voltage and current transformers, disconnect switches, circuit breakers, and three phase low voltage service for auxiliary power.
- Standard Committee
- PE/SUB - Substations
- Status
- Active PAR
- PAR Approval
- 2021-12-08
Working Group Details
- Society
- IEEE Power and Energy Society
- Standard Committee
- PE/SUB - Substations
- Working Group
-
WGI1 - Power Electronics Equipment Working Group
Learn More About WGI1 - Power Electronics Equipment Working Group - IEEE Program Manager
- Patricia Roder
Contact Patricia Roder - Working Group Chair
- Jeffrey McElray
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
No Active Projects
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
1623-2020
IEEE Guide for the Functional Specification of Medium Voltage (1kV to 35kV) Electronic Shunt Devices for Dynamic Voltage Compensation
General guidelines on the preparation of a functional specification for a solid-state electronic shunt device used to compensate voltage fluctuation are provided in this guide. Devices rated medium voltage (1 kV to 35 kV) are covered in this guide. In general, these devices contain: an inverter, a rectifier or dc converter, an energy storage device, and a coupling transformer. The device is typically connected in parallel with the network using a coupling transformer.
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
1623-2004
IEEE Guide for the Functional Specification of Medium Voltage (1 kV - 35 kV) Electronic Shunt Devices for Dynamic Voltage Compensation
This document provides general guidelines for the preparation of a functional specification for solid-state electronic shunt devices used mainly for compensation of voltage fluctuation. The guide covers devices rated to medium voltage (1 kV-35 kV). This device contains in general: an inverter, rectifier or DC converter, energy storage device, and coupling transformer. The device typically is connected in parallel with the network using a coupling transformer.
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
1585-2002
IEEE Guide for the Functional Specification of Medium Voltage (1- 35kV) Electronic Series Devices for Compensation of Voltage Fluctuations
An approach to prepare a specification for an electronic device connected in series to compensate voltage fluctuations is presented.This guide intends to provide a base specification to allow users to modify specific parts of the document to meet their practical needs.